* JBL Club A5055 - "NEW" 5 Channel Amplifier

THIS ITEM IS NO LONGER AVAILABLE

JBL Club A5055 - "NEW" 5 Channel Amplifier

Value engineered car amplifier with JBL power and performance

The Club A5055 5-channel amplifier delivers a powerful 50-Watts RMS to each of the front and rear speakers in your car, and a pounding 500-Watts RMS to the subwoofer channel — a much smarter ratio of subwoofer-to-full-range power than what is typical in 5-channel amps. You can also bridge the amp to 3-channel mode to deliver 140-Watts RMS to your front speakers while driving your sub with 500-Watts RMS. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics. The subwoofer channel features a low-pass crossover, selectable bass boost, and phase switch to optimize subwoofer performance.

General Specifications

• 5 channel car amplifier
• 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
• 65 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
• 140 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
• variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
• low-pass filter (32-320 Hz, 12 dB/octave) on subwoofer channel
• bass boost on subwoofer channel (0-12dB at 45Hz)
• phase switch on subwoofer channel (0, 180 degrees)
• preamp and speaker-level inputs
• fuse rating: 30A x 3
• 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
• WxHxD: 360mm x 51.3mm x 180mm

What’s in the box

• One Club A5055 five channel amplifier
• 4 Bare wire-to-RCA adapters
• Six 30A ATO fuses (3 installed, 3 spare)
• Remote bass control module
• 6.5’ Remote control cable (RJ-25 plugs on both ends)
• 2 Self-tapping screws for remote (M3 x 15mm)
• 4 Mounting screws (M4 x 53mm)
• Owner’s Manual
• Two JBL stickers
• 1 logo badge

Optional

• 4 Gauge Amp Kit

1. Due to continuous product improvement, specifications, pricing, and design are subject to change without notice
2. Big Noise cannot be held responsible for discrepancies/inconsistencies that may occur due to vehicle manufacturing changes or options or damage that may occur in the vehicle during installation of components. All application data is subject to change