Dynamat 10455s Xtreme Single Sheets (457mm x 812mm)

Dynamat 10455s Xtreme Single Sheets (457mm x 812mm)

Dynamat Xtreme quiets annoying road noise, improves a speaker's dynamic range, and makes for a more comfortable driving experience. You can quiet down the noise and get better sound. The Dynamat Xtreme Bulk Pak is the perfect amount of Dynamat Xtreme for any medium to large sized job. Dynamat Xtreme to damp vibrations and get a more solid ride. Use on rear decks, doors, floors, roofs, trunk lids, trunk floors, and wherever noise resonation is an issue and installation will not interfere with the normal operation of the vehicle. Get more bass, more music, lower road noise and better sound.

Contents: (1) 18"x 32" (457mm x 812mm) pieces of Dynamat Xtreme
Application: Use on rear decks, doors, floors, and trunk floors. 

Dynamat Xtreme is a black butyl-based core with 4 mil aluminium constrain layer, and craft paper release liner.

Dynamat is a patented, lightweight elastomeric butyl and aluminium constrained-layer vibration damper. Dynamat conforms and fuses easily to sheet metal and other hard substrates. Material performance is optimized for temperature ranges between 14°F and 140°F (- 10°C to +60°C). Material can withstand temperature extremes between -65°F and +300°F (-54°C to +149°C) and is highly resistant to aging.

Installation: Use scissors, knife or die to cut Dynamat to the desired size and shape before removing the release liner. Next, remove dust, grease, moisture, and other foreign matter from the application surface. Peel off the release liner. The simplest application technique is to bend the mat slightly and attach it along its shortest edge. Press the mat firmly into place, using a Dynamat roller for larger pieces. The roller reduces the risk of leaving air pockets, which reduce Dynamat’s sound damping capacity. Finish by covering all seams and wiring with DynaTape to ensure a professional look and finish. The temperature of the mat and application surface should not be below room temperature during fitting. Heating the material is not necessary.

1. Due to continuous product improvement, specifications, pricing, and design are subject to change without notice